Hi all,

 I have an energy chip which sending me an output in form of pulses. I have connected the output pin of that chip as an IO to nueron chip... i have also written a small code to accept this pulse and display it on smartserver... the prob here is sometimes the server shows the counted pulses andmost of the times it does not show and it jus shows values as read as 0... why is this happening??

 Hi

Why can't you just connect the output of the chip directly to the pulse counter of the SmartServer? Regaring your problem, one would have to see you source code to have a chance of telling what is going wrong. I don't even understand, what you did. You connected the chip to a neuron and wrote some code. So you programmed the neuron? Then this is the wrong forum.Or did you write an FPM? Bet then how did you get the signal into the FPM?

    Regards

    Thorsten